Required for assembly: file, filler, two part epoxy glue, super glue, (screws included), (springs included), fine grease, modeling knives. Paint: car primer, mat black, silver or alluminium. The assembly is reasonable easy, kit comes preassembled with no glued parts, study with attention the instruction pages before disassembly the gun so you will lost less time to rebuild it. Test fit each parts before gluing together. You may need to clean the pieces by putting of medium grade sandpaper (40/60 grade), also you may need to fill some air bubble. When you are happy with the fit of each parts, you can start to paint them, use a primer so you can easily detect other small imperfection, when you are satisfied of the primered surface, paint all parts with alluminim color, for a better result finish with a coat of clear paint.Paint the grip with Flat Balck color.Use the 5-minutes epoxy glue to join all parts that compose the front barrels. |
 |
|
|
|
Insert view-finder inside the up barrel, glue it using 5 minutes epoxy glue, make attention to not grease of glue the lower parts of the view-finder where will be place the pivot for the rotating cylinder. |
 |
 |
 |
Insert the lower barrel, it goes inside thanks to a slide surface, use some epoxy glue to fix it, remember to not grease
the pivot's place, as you can see the cylinder's pivot now is mantained in side from the upper and lower barrel
but can easily roll free. |
Use the super glue to fix the smal metal lever's secure block. |
Place the cylinder's pivot over the view-finder on premarked space , don't glue it!, this parts need to be free for rolling cylinder action. |
|
|
