Required for assembly: file, filler, two part epoxy glue, super glue, (springs included), fine grease, modeling knives. Paint: car primer, Metallic blue color, Brown colors. Study with attention the instruction pages before start to assembly the gun. Test fit each parts before gluing together. You may need to clean the pieces by putting of medium grade sandpaper (400/600 grade), also you could have to fill some air bubble. When you are happy with the fit of each parts, you can start to paint them. Use a primer so you can easily detect other small imperfection, when you are satisfied of the primered surface, paint all parts, for a better result finish with a coat of clear paint. |
IMPORTANT If you are planning to build the Harlock's gun with working laser, before paint all parts, go thorugh instructions to understand some holes and modification you have to do.You have to use a solder for electronics connection, if you have not familiarity with solder ask to a competence person. Wrong connection may damage the laser. LASER IS DANGEROUS, AVOID DIRECT EYE EXPOSURE |
 |
Wash all parts thoroughly with soap and warm water. After paint all parts with primer coat use a filler for the air buble and imperfection.Lightly wetsand all parts. |
|
|
This three steps resume where the wires have to go through. |
 |
The electronics connection are reasonable easy. If you never had used a solder, ask to a competence person. |
 |
|
|
|
