Required for assembly: file, filler, two part epoxy glue, super glue, (screws included), modeling knives. Paint: car primer, mat black, silver or alluminium. The assembly is reasonable easy. Test fit each parts before gluing together. You may need to clean the pieces by putting of medium grade sandpaper (40/60 grade), also you may need to fill some air bubble. When you are happy with the fit of each parts, you can start to paint them, use a primer so you can easily detect other small imperfection, when you are satisfied of the primered surface, paint all resin parts with preferred colors. Use the 5-minutes epoxy glue to join the resin parts.Shine the metal parts for give alluminium surface appearance or or spry them in color, use a very fine sand paper for precleaning the metal , then with dremmel tool, use a brass brush, at lowest dremmel speed shine the surface very gently.You will sure noted that the gun have got a preassambled ejection magazine mechanism, please don't try to disassamble that parts, paint the gun with built in mechanism. |
ATTENTION: BEFORE START TO BUILT THIS KIT FOLLOW THE FIRST PAGE INTRUCTION STEPS
Drill side to side the holes for the safety . |
Drill the trigger's premarked hole |
|
Insert the in the main gun's body. |
Barrel with trigger in place. |
Test that the holes you made to coincide and that pivo have no problem to go through. |
Don't take out the pivot, for now! |
Now with the barrel in place drill the hole for the screw that will definitively will block all. |
Place the screw. |
Insert the spring. |
Insert the breechloader inclining it as show in the image. |
|
|
Test that the breechloader works well. Now you can start to disassamble the gun and prepare all parts to be painted. |
